Air / Water After Cooler
E.D.S Aftercoolers are installed in compressed air systems to reduce compressed air temperature and moisture content.
They consist of a heat exchanger made up of copper tubes supported by aluminum cooling fins. A high-efficiency axial fan forces ambient air over the heat exchanger providing the necessary cooling effect.
The compressed air is cooled down to approximately 10°C above ambient temperature. This cooling effect condenses a high percentage of the water vapor into a liquid with is separated from the air stream by the CCS centrifugal separator installed at the aftercooler outlet.
The installation of an EDS Aftercooler ensures the maximum performance and protection of all equipment, such as refrigeration dryers, adsorption dryers, and filters, positioned downstream of this unit.
Water Cooler – Technical Specs


(A) Nominal cooling capacity conditions: Cooling water in 30°C, Water out 36°C, Air in 99°C, Air out 40°C
(B) Nominal cooling capacity conditions: Cooling water in 25°C, Water out 30°C, Air in 99°C, Air out 33°C
Air pressure 7 bar, Water pressure 3 bar
Air Cooler – Technical Specs
- Maximum inlet Temperature: 90℃
- Capacity : 1.8 – 36 M3 /min
- Air Connection : 1″ ~ 3″
- MAx. Working Pressure: 16 Kg/cm2
- Flow Rate: Refers to 99 °C INLET 35 °C AMBIENT
- + 10 °C OUTLET OF AMBIENT TEMP.


Air Cooler – Optional Equipment

Electric auto drain with Y strainer

Automatic drain valve

Switch padlock on-off power